Episode 105 Freeform Router Bowl

Using the Amana Tool bowl bits from Toolstoday.com, I create a freeform double (interlocking) bowl

Bowled Over

This slideshow requires JavaScript.

Routing a bowl, using the Amana Tool bowl bits from Toolstoday.com

Including rounding over the edge with about the smallest 1/4″ roundover bit there is (and the smallest bearing I think I’ve ever seen too!)

Check out the next edition of The Shed magazine for a full description and step by step for making this project.

Busy weekend

Just managed to knock off the next article for “The Shed” magazine.  This one is on using a router to make a bowl, using the Amana Tool bowl-making bit from Toolstoday.com

Haven’t tried it before, and it was a very interesting exercise.  The Amana Tool bit worked out very well  – a very nice bit that worked very well, even when shucking off a good amount of material.  There was no tendency to kick back either.

There are a couple of sizes available in 1/2″ (and a couple of 1/4″)

4946

I won’t pre-empt the article – you’ll just have to read the next edition of “The Shed” magazine!

 

%d bloggers like this: