Workshop Architect

I’ve been having a bit of a brainstorming session today about workshop design and layout (with myself, unfortunately – bit of a one-way conversation), and was lamenting that there isn’t such a person as a workshop design specialist, who can take all the tools and workflows, and come up with an optimum design.

What is bugging me, is even with the significantly improved floorspace, I still seem to be lacking a good workshop area – open space, perhaps (at worst) with a workbench in the middle.

As much as it is great having machines with plenty of space around them, finally being able to access those machines easily, I haven’t gotten the layout right yet.

Unlike some, at least I have access to the collective wisdom of all the readers out there, so let’s brainstorm. Ideas on the table and let’s see if we can’t work this through.

In no particular order, here are some of my thoughts.

1. The mezzanine. When finished, it is going to have a good amount of floorspace, and although limited in a number of areas, how can this space be best utilisted? Limitations include:
– access (obviously), being upstairs, and accessed by ladder
– floor load capacity. Not sure the /m2 load rating – will have to find out.
– head height
However, working around these limitations, is there any function (other than storage of items not needed on a daily basis) that can be located to the mezzanine?

2. Dust extraction. The dust extraction layout will have to be compromised to work around workshop layout, and not the other way around. However, is having the extractor on the mezzanine a good option. I’m having definite second thoughts. I put it up there to a. free up workshop floorspace b. for it to be inside the main shed, as it draws a lot of air, and if outside the main shed, that is a lot of hot (or cold) air that would be drawn into the workshop, and c. as that would make it generally central to the machines it is drawing from. On the other hand, having it in the timber store next door gives better access, better noise separation, better workshop air quality (particularly on the mezzanine).

3. Infeed and outfeed on the jointer and thicknesser. These machines are claiming a lot of the new workshop’s floor space. Both in having area around the machines to walk, but also material workflow area. Is there a better layout? Would there be a benefit in moving one (or both) to the long, narrow timber store? Especially if the dust extractor is going in there. Or is there a better way to manage their floorspace requirements? If it was an option, would replacing the two separate machines with one combo be a better solution? There are some pretty interesting alternate machines out there that could perform both functions in one footprint, and with one infeed and outfeed area.

4. Location of the router table. Would it be better up against a wall (rear edge) as I had it in the previous workshop? Should it swap position with the workbench that is near the lathes?

5. Things I like about the current layout: The lathe area. That back section of the workshop is still looking as I envisaged it. The rest though, really not sure if it is right, and how best to tweak it.

6. Storage. Still a big problem. I have a lot of things still packed in crates, waiting for their new homes to be revealed. Still unsure what a good solution will be.

7. I still really need to move some machines and tools on to new homes, such as the TS10L tablesaw, and the Torque Router Master. The list of machines and tools to move on is also growing. I have a bunch of cheap clamps (quick action, Irwin style, but much cheaper) to go, a scrollsaw, even a radial arm saw. The big ticket items need to go quickly though – need the funds to pay for some of what the workshop has cost, and they take up significant room too.

So that is the current list – any thoughts?

%d bloggers like this: