Burl meet Torque

Another burl found itself being flattened at the hands of the TWC at Ballarat last weekend. This one had quite a curvature, with over 1″ from edge to centre on the cut side.

20120406-221422.jpg

For a thicknesser, this would be a nightmare. For the TWC this was a piece of cake.

20120406-221635.jpg

You may be able to see the separate passes in the photo- this is because at the time of the photo, I was working on maximum material removal (4-5mm per pass, to the full width of the cutter). This means the grain on adjacent passes got cut in the opposite direction to the previous, resulting in a different reflective surface- you can see the passes, but it still feels flat.

The final pass is done with very little material removed 0.5mm depth of cut, and maximum 1/2 the cutter width max, so all the grain is pushed in the same direction.

Either way, a few passes with the ROS (random orbital sander) removes any minor irregularities.

The problem for the thicknesser is both the tortured grain – in all directions so tearout is likely. The cutter direction on a thicknesser makes this even more likely, with the cutter scooping the material up, out of the surface.

Secondly, stabilising a burl to pass through a thicknesser is also tricky. With drive rollers pushing down before and after the cutter, the chances of the burl shifting and getting a massive kickback from the thicknesser is pretty high.

On the Torque, the cutter direction is horizontal, the amount of material removed each pass can be minimal, and is not over the entire burl width simultaneously, and there are no feed rollers to potentially destabilise the burl during the cut.

Thicknessers obviously perform a very useful role, but when their idiosyncrasies work against you, the Torque Workcentre takes over!

2 Responses

  1. Gday stu what size is that extraction hose is it a new larger dust shroud from twc?

    • It’s 2.5″ – I still have the 1″ one, and that was a prototype. Aaron never got around to supplying me with a final version of the guard, or of the Triton router mount.

      At the show it was one of the new guards. Worked well with the Oneida Ultimate2 cyclone & Festool Cleantex. Would work really well with a high volume 4″ system (with reducer near the dust guard).

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: