Finishing off the boards

From the thicknesser, the final step in producing the components is the tablesaw.

With the side against the table (and now either side can be used as the reference, both being flat, parallel to each other, and at 90 degrees to the machined edge), and the planed edge runs against the fence.

The boards are then cut to width.

Ripping the board

Next, the fence is moved out of the way and the mitre fence added to the mitre slot.

Mine is the Incra, and like many, has a T end to the bar.  Rather than fluff around trying to insert the end at the near end, place the bar into the slot – it will ride up because of the T end.  Slide it forward past the end of the table, so the T slot clears the end, then drag it back.  So much easier than the other!

Crosscutting the ends

With the Incra Mitre 1000SE and Shop Stop, it is very easy to both dock the ends, and cut the boards to an exact, repeatable length.

First crosscut one edge, just enough to remove any checking, then flip the board over to dock to length.

Box sides

The final, nicely figured box sides.  Each is exactly the same thickness, the same width, the same length as its matching side, all ready for whatever joinery method is going to be chosen.

The extra, significant satisfaction that these boards have been formed, hewn from the trunk of a tree in your own workshop.

10 minutes…….

Last gasp chance to have an offer considered for the TWC!

Bid now, or have to pay full retail!

And……..its sold.  Thank you ball boys, thank you linesmen.

Update.  The original purchaser has withdrawn after the fact, so now I am out of pocket for the machine (it was a sale on behalf).

It will be readvertised shortly.  No auction.

%d bloggers like this: