Completing timber dressing

The boards have been resawn on the bandsaw, and had a side and edge dressed on the jointer.  Next step is the thicknesser.

15" Thicknesser

I have a 15″ thicknesser, with a fixed head and the table rises and falls.  I prefer this style of thicknesser, but it isn’t everyone’s cup of tea.

The other version has a fixed table, so any additional infeed and outfeed support can remain at the same height, and the motor and blades rise and fall.  Winding the height down isn’t a problem – gravity and all that, but increasing the height is a lot more work, especially with the weight of a decently-powered induction motor overhead as well.

On the other hand, my thicknesser has a motor in the cabinet, and rise and fall is only the weight of the table – very smooth, very easy.  Added bonus, as the head doesn’t move, I have my drum sander located on top,  and a very functional arrangement it is, especially as the thicknesser and the drum sander both have the same requirement for infeed and outfeed.

Dressing boards

With the side dressed on the jointer face-down, the boards are fed through.  There is no point rushing the process – a little taken off each pass will still result in a finished product very quickly.

If I had a spiral head, things may be a little different, but I still have a thicknesser head with straight blades, so loading the machine and chipping away needs a little more finessing.

This doesn’t refer to the ‘spiral’ heads that have a bunch of the small square cutters arranged in a spiral around the head, but are still presented to the timber straight on.  This means the loads on the blades and machine are much less, but they are still chipping at the surface.

Instead, there are spiral heads where the small blades each present to the surface at an angle, producing a slicing motion.  This gives the best finish, combined with the benefit of much lower loads on the tool, and excellent waste clearance.

Completed boards

The boards, now complete (and you can see the bookmatching, if I intended to use the timber for that).

In this case, I now have a dressed side, the other side also dressed and parallel to the first side (and the boards are a uniform 10mm thick).

One edge is also flat, and at 90 degrees to both sides.  This side will be very relevant for the next step – the tablesaw.

How a thickness planer works.

From Wikipedia - a diagram of thicknesser operation

An illustration of the operation of a jointer ...

From Wikipedia - compare the above operation to this one which is how a jointer works.

%d bloggers like this: