Acrylic Wizard

Wanted to see how well acrylic blanks can be machined by the Beall Pen Wizard.

Biggest frustration is you can’t just jump into a project. You have to go through all the steps to turn a pen beforehand. Not a problem (unless you are impatient to try an idea out!)

This was very much a test- I wasn’t so worried about the end result, so long as there was a reasonable degree of confidence that it could be achieved.

The blank is probably too (colour) detailed to also be machined, so I’ll look at plainer acrylics for when I plan to use the Wizard to finish the pen off.

In this case, I used a side-mill bit, and ran a spiral flat on 4 sides of the pen. Then did 4 additional lighter passes in between each of the other 4.

Remounted the resulting pen on the lathe (not turning), and tried the Dremel buffing wheel. Point to note- the heat generated exceeds the melting point of the acrylic!

Then tried the traditional acrylic sanding pads, which worked better, although rounding over and softening the result.

So another successful experiment, with more lessons learned. For one, don’t load up the cutter on the workpiece if the gearbox is in reverse- you are likely to undo the spindle!

Again, experienced a bit of flex and play in the jig, but a decent result (for a beginner!) was still achieved.

3 Responses

  1. Stu

    Would a regular dremel work for this?

    • Yes not a problem for the regular dremel.
      The fordem hand peices and the Proxxon grinders will also work just need different tool holders.

      • Saw the Foredom and would have been very tempted, but for the price. Its ability to run 1/4″ router bits was especially appealing.

        I’d be interested if there is a mount that specifically takes the flex drive of the Dremel – it has a smaller thread than the main body. That would take a lot of the load off the Pen Wizard. Thinking of getting a longer thread for the Foredom mount bolt, and seeing if I can use the flex drive in that.

        In any respect, I’ve turned the tool holder bolts upside down, so the nuts are holding the holder 😉 making it easier to remove and replace the tool for bit changing.

        Cool tool – offers lots of possibilities! Like a grown up’s version of a Spirograph, working on pens in 3D, rather than 2D on paper.

        Wonder if you could mount it with a laser engraver?

Leave a Reply to Stuart Cancel reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: