Different Torque Tool Configurations

I’ve been running through the different tools that can be mounted to the Torque Workcentre, getting a feel for the pros and cons for each, and just some of the ways the TWC brings a different element to each of them.  The more I play with the tool, the more I get to iron out any setup issues and get to know how to tweak and finetune it.  As I’ve said in the past, the platform has a solid engineering base, and basis, so fine tuning is all about realising its potential, rather than covering up defects.

Router Mount (guard removed)

First out of the blocks is what has been seen a number of times already – overhead mounting of a router.  In this case a Triton 2400W, with a 6 flute surfacing bit.

Degrees of Freedom

Each tool mounted can be rotated around both the X and Y axis.  In this case, the X axis allows +/- 45 degrees.  Around the Y axis, it can be theoretically rotated through 360 degrees, although practically you’d go a maximum of 90 degrees, which is very cool being able to have a horizontally mounted router. (Obviously these changes in tool orientation are NOT done while the tool is running!)  Whatever the orientation, you still have the plunge mechanism operational, so again for example, if the router is horizontal it can become a horizontal mortising machine.

Copy Attachment

Each tool can be used with the copy attachment, and not necessarily for copying! In some cases it provides additional control over the tool, and a degree of separation which can be a safety point, as well as providing better visibility of what is happening at the cutting point. As Larry has pointed out, the copy attachment is also an excellent storage for the hex keys.  And it is very easy to remove and replace when necessary.

Router Guard / Dust Extraction

The tool guard / dust collection(which is optional), I would regard as a must have.  The brushes around the edge help trap particles, and the hose itself is orientated to collect particles which get thrown in that direction by the direction of spin of the bit.

You can again see in this photo how successful the Walko surface clamps work.

Drill Mounted

The simplicity of the drill mount is misleading compared to the capability.  No drill press has the range or versatility that the TWC has with the drill mounted.  It won’t result in me parting with my dedicated drill press (it is too handy having one ready to go at a moment’s notice, and it has obvious power benefits), but it has severe limitations in range and capacity compared to the TWC!

Circular Saw Mount

Mounting a circular saw is also possible with the saw mount.  Here I have mounted one of the largest circular saws out there – the 2400W 9.25″ Triton.

Saw Mount 2400W Triton (crosscut)

The saw can be mounted for crosscut, or ripping, and presented at any angle.  And still, the saw is used in its most stable position and the plunge on the carriage is used to bring the tool to cutting depth.

Saw Mount Alternate Orientation 1800W Saw (rip)

And still we haven’t exhaused how the saw can be used.  If the arm was rotated around the Z axis, you could then do coving for the full length of the workcentre.  And that is just one thought of many.

%d bloggers like this: